Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"Please check if the correct RDA file is selected" after uploading rda file
20-Sep-2017, 01:13 PM (This post was last modified: 20-Sep-2017 01:15 PM by jamesp.)
Post: #1
"Please check if the correct RDA file is selected" after uploading rda file
If you receive a message "Please check if the correct RDA file is selected", when you select the rda file to use and you have uploaded a file which you previously downloaded, please pay attention to the following.This issue arises with the RiboSeq Analysis tools. The tools expect a file with a specific name and downloading the file causes a change in the name of the file. For example you may find square brackets and underscores in the name of the downloaded file. When you upload a file with such name you may find that the uploaded file is empty or there is a message to say that the file contains "inappropriate content".
Therefore it is recommended to modify the name of the file before upload as follows:
For Triplet Periodicity (Step 2), the name of the file should be Prepare riboSeqR input (R data file)
For Metagene Analysis (Step 3), the name of the file should be Triplet periodicity (R data file)
For Plot ribosome profile or Differential Translation Analysis (Step 4), the name of the file should be Metagene analysis (R data file)
The file extension should be .rda
You could also have similar issues if you rename files between steps.

Regards
jamesp
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

GWIPS-viz | Return to Top | Return to Content | Light (Archive) Mode | RSS Syndication